As said above, adjusting the cable adjusters only adjusts the cable, (!).
The lifter should be adjusted first, then the cable slack set.
Do this:
Quote:
|
Originally Posted by Me, lots
Slacken off cable adjusters at top and bottom, loosen lifter locknut, back out screw a bit, ensure that lifter arm is as far down as it will go, gently turn screw in until it contacts pushrod, back it out a bit, (~1/8th of a turn), then nip up the locknut, roughly adjust cable with lower adjuster - not too tight - then with top adjuster ensure that there remains a little slack all the way from lock to lock.
|