SV650.org - SV650 & Gladius 650 Forum - View Single Post - Bar End Nut

03-01-13, 09:35 AM

If you have access to a air compressor you could remove the other bar end and blow it out from the other end.

Re the nut any nut of the same thread will work all it does is grips to the rubber expansion grip I had to do this as a mod after fitting Renthal bars as the original flange nut would not fit inside the end of the Renthal bars works just fine for me.

03-01-13, 09:35 AM	#9
Iantson Guest Posts: n/a	Re: Bar End Nut - Where to Get? If you have access to a air compressor you could remove the other bar end and blow it out from the other end. Re the nut any nut of the same thread will work all it does is grips to the rubber expansion grip I had to do this as a mod after fitting Renthal bars as the original flange nut would not fit inside the end of the Renthal bars works just fine for me. Last edited by Iantson; 03-01-13 at 09:36 AM.