SV650.org - SV650 & Gladius 650 Forum - View Single Post

21-04-13, 07:46 PM

yeh seen the woodcraft covers, just a bit pricey, figured i could get a 2nd gen cover n forget about it all together.
currently running mine with some instant gasket on it, it was fine n stayed sealed for about 7 months, but its starting to seep through again now. recon the loctite black silicone is better than instant gasket?

saying that, i might just re-seal it with loctite or instant gasket again, even if it only lasts 7 months each time, be a long time til i break even with the cost of buyin a new cover...

21-04-13, 07:46 PM	#9
phatwheels Guest Posts: n/a	Re: 1st gen clutch cover swap for 2nd gen? yeh seen the woodcraft covers, just a bit pricey, figured i could get a 2nd gen cover n forget about it all together. currently running mine with some instant gasket on it, it was fine n stayed sealed for about 7 months, but its starting to seep through again now. recon the loctite black silicone is better than instant gasket? saying that, i might just re-seal it with loctite or instant gasket again, even if it only lasts 7 months each time, be a long time til i break even with the cost of buyin a new cover...