Ok so here we go its food time so also update time!!
Right so finished welding up the manifold so to speak
Now to start on the down pipe from the turbo so first make a bendy bit cos I'm to cheap to buy one or cos it's to late in the day!! Oh and a flange!!
Fit the flange and add the bendy bit made....
Now lets see if the turbo spins up shall we, it's going to get loud!!!!
Edit: seems the video link from photobucket doesn't work!!
Whoop whoop it works!! The worlds largest amount if exhaust leaks but hey nothing's on tight yet!!!
New exhaust outlet as I've no idea on a high or normal level so just a pipe right now!!
Next!!!
Lets look at the carbs and see what to do next!!
Thing is we've got to get the air in as equally as possible to feed either carb so time to make a plenum.... Oh and no sharp edges as that will cause the airflow to become turbulent causing static and vacuum areas, this equals BAD so again lets see what can be done within everyday prices!!
Getting a little tired so employ a mate to help, cheers Larry!!......
And 'poooof' as if by magic there's a plenum chamber flowed well given the intake point!!!!!
Ok so we're getting there, so easy stuff time. New fuel pump, out with the vacuum diaphragm pump and in with the elecy pump YAY!!!
And position
That's it for tonight, been busy busy. Hope it's a good read