SV650.org - SV650 & Gladius 650 Forum - View Single Post

Bibio · 24-02-15, 01:17 PM

well thats the pointy front end conversion speedometer drives almost ready and will be in my grubby paws this time next week all finished and ready to send out to folk that are interested.

as for the curvy well lets just say it's going to have to be a complete redesign apart from the rotor. i was hoping to use the sensor down stand from the pointy but thats looking like a no go. i'll try and get something for the curvy for the summer but dont hold your breath as i'll need to get funds back into the kitty first. i might just start with the adjuster plates and work from there, i was hoping to punch them out on the punch press but at 4mm SS the machine wont like it so its laser cutting again.

i also have 18 Gizmo kits ready to post off.

24-02-15, 01:17 PM	#87
Bibio Member Mega Poster Join Date: Jul 2008 Location: here as devil's advocate Posts: 11,569	Re: svbits.co.uk showcase well thats the pointy front end conversion speedometer drives almost ready and will be in my grubby paws this time next week all finished and ready to send out to folk that are interested. as for the curvy well lets just say it's going to have to be a complete redesign apart from the rotor. i was hoping to use the sensor down stand from the pointy but thats looking like a no go. i'll try and get something for the curvy for the summer but dont hold your breath as i'll need to get funds back into the kitty first. i might just start with the adjuster plates and work from there, i was hoping to punch them out on the punch press but at 4mm SS the machine wont like it so its laser cutting again. i also have 18 Gizmo kits ready to post off.