SV650.org - SV650 & Gladius 650 Forum - View Single Post

Red ones · 12-04-16, 02:05 AM

From SVRider:
C42 is ignition input to ecu not present. Check the 4 pin green connector below tank open and spray in contact cleane then remake. If you have a volt meter you should have around 6vdc from the orange/ red wire to ground when the ignition is on. If not likely the ignition switch at fault.

12-04-16, 02:05 AM	#21
Red ones Member Mega Poster Join Date: Jul 2003 Location: Hertfordshire Posts: 1,422	Re: Slow Rev Limiter Bounce on K6 From SVRider: C42 is ignition input to ecu not present. Check the 4 pin green connector below tank open and spray in contact cleane then remake. If you have a volt meter you should have around 6vdc from the orange/ red wire to ground when the ignition is on. If not likely the ignition switch at fault.