SV650.org - SV650 & Gladius 650 Forum - View Single Post - Meta 357v2 Installation (deinstallation) instructions?

aesmith · 08-03-17, 08:20 PM

Can't access the loom at the moment since I can't get the left hand side panel off. So I'm having a to see if the wires can be rejoined at the alarm end. With the alarm disconnected of course.

The starter cutout is easy enough, it's the two wires on the small two pole connector.

I'm struggling to work out the ECU immobiliser though. I expected to find it interrupting the Orange/White wire that feeds all these things, but buzzing through I can't find a pole on the alarm connector that corresponds - six of them connect to positive when the ignition switch is on, but they stay connected when the kill switch is moved to Off.

Any ideas where else it would cut the ECU and/or fuel injection? Maybe on the negative side of something? When it was working I got a brief buzz when the immobiliser was disarmed, suggesting that the fuel pump was off until then.

08-03-17, 08:20 PM	#9
aesmith Member Join Date: Mar 2013 Location: Aberdeenshire Posts: 966	Re: Meta 357v2 Installation (deinstallation) instructions? Can't access the loom at the moment since I can't get the left hand side panel off. So I'm having a to see if the wires can be rejoined at the alarm end. With the alarm disconnected of course. The starter cutout is easy enough, it's the two wires on the small two pole connector. I'm struggling to work out the ECU immobiliser though. I expected to find it interrupting the Orange/White wire that feeds all these things, but buzzing through I can't find a pole on the alarm connector that corresponds - six of them connect to positive when the ignition switch is on, but they stay connected when the kill switch is moved to Off. Any ideas where else it would cut the ECU and/or fuel injection? Maybe on the negative side of something? When it was working I got a brief buzz when the immobiliser was disarmed, suggesting that the fuel pump was off until then.