Re: New member - Cafe Racer (ish) project.
Thanks. The exhaust is made by Scorpion - the high level oval 400mm version with removable baffle . It comes highly polished (with sticker) but as I wanted the brushed finish the sticker had to come off. The springs on the link pipe were added as I liked the look. Getting the seat and exhaust to align was a bit of a pain. I added rose joints to the subframe to lift the back end a little. To be fair the standard set up is not too far off. Hopefully if i've done this right there should be the details of the exhaust below...
|