View Single Post
Old 05-01-20, 11:04 PM   #31
DamoK4
Member
 
Join Date: Jul 2019
Location: Lancashire
Posts: 134
Default Re: Will an R1 front master cylinder fit?

Quote:
Originally Posted by redtrummy View Post
Removed my front end without any special kit. Lifted the front end up and used rope from a joist in the garage. Put a supporting jack under the engine and progressed from there. Some years ago though, looks as if I will have to repeat as the oil seal in one fork leg is giving up the ghost.
I don't have a garage anymore. It was absolutely knackered when i moved in here so it got pulled down. It is getting done this year though. My springs may be shortly after. I'll have to make sure i get some strong joists

Had a re roof, re-wire, new heating system, kitchen, ceilings, knocked a wall out. Just done a big lawn. Been a busy bunny. Mrs agrees the garage is next before i do the bathroom
DamoK4 is offline   Reply With Quote