Quote:
Originally Posted by 600rob
Ill probably use my 115mm grinder for this on just im case.... Might end up going through the swing arm i used my 230 
was going to ask, does the end can sit at a fairly mig-high level at 120mm?
Most of the other threads/info ive found suggests between 50-65mm up from the weld.
(although i am considering one of the high level exhausts from delkevic) |
120 mm was the length that Blackwidow said on the instruction sheet that came with the silencer.
I bought the 400mm long one (oval) & it's further back than I would have liked, I think I'd have gone for the 300mm one had I known. The end can is sitting 180mm from the underside of the tail & parallel with it, using the original mounting on the rear footrest.
I got the 400mm one because I read that the shorter ones can cause issues on one of the other threads, plus I want to go to work on it in the summer & I leave at 6am...
The delkevic link pipe is probably different to the one Blackwidow supply with their end cans.