Quote:
|
Originally Posted by Sid Squid
......., make a hole in the end and put the bar end screw with a washer on it through the hole so it's secured at both ends, this is a good idea if you find the muffs pull on the levers at higher speeds.
|
Got to say 'Thanks you Mr Squid' . Think my muffs are sorted now.
Thought I'd sorted it out at the weekend using some ally strip 3/4 inch wide as a frame for the front bit.
It did Keep the muffs of the levers but was not quite right especially as not being able to adjust the muffs independently( continuous strip of Ally running through both).
.....so I'm thinking 'what's the best way..' until I say your post.
So this morning sniped the Ally strip in half and applying your tip in addition to the Ally frame , it's more or less perfect now
.
I'll even go as far as saying 'The best ride I've had with Muffs'
.
Cheers
Ben