Quote:
Originally Posted by yorkie_chris
But check the output voltage direct at the regrec just in case
|
Did you try this as yorkie_chris suggested? It will be difficult to get the probes into the back of the connector (the connector must not be disconnected for the test). If you measure a higher voltage at the reg/rec it implies there's a problem within the bike's loom. If you measure the same voltage as measured at the battery it implies the reg/rec is faulty.
If this proves impracticable, you could see if a regular spade connector would fit the reg/rec socket and make a couple of temporary 12 gauge lead connections between reg/rec and battery (ideally with a 30A fuse in the positive lead - but for quick test it would be ok without - but don't cross the polarities - you'll get smoke).
A better way would be to get the correct plug but then you need a crimp tool unless you know a friendly auto electrician (I'm sure most would crimp a new lead for you for a beer or two). In case you do, they sell the plugs here:
https://www.corsa-technic.com/catego...ategory_id=101
and here:
http://easternbeaver.com/Main/main.html