corkzak

Hi guys I need help.
I bought some LED leading indicators for my Gladius. When connected to battery directly each led comes on one at a time from left to right and then starts again from left to right etc. Problem when connected to bike only the first 3 LEDs blink on one at a time. I went back to Alchamy Parts and they said I have too bridge two pins on the indicator relay. Trouble is I don't know what pins to bridge. I have changed the relay for a LED one but that only changed the flash rate. Can anyone help me please

Specification:

12V
Bullet style wire connectors
Sequential indicator repeater style
Finish: black plastic
Sold as a pair
For measurements, please refer to our photos
These indicators are not homologated / E-marked or DOT approved (for American use)

HOW TO MAKE THEM WORK:
Assuming your bike had a 3 pin flasher relay, remove it. The 1st pin is the live feed, the 2nd pin is from the switch and the 3rd pin is earth.
You just need to bridge the live feed and the switch together - forget about the earth.
You can fit an in-line fuse, but it's usually not necessary.

My relay is 7 pin Suzuki LED relay