SV650.org - SV650 & Gladius 650 Forum - View Single Post

TSM · 07-02-16, 10:09 PM

Today I have mostly been doing a crap job of fibreglassing the 675 fairings on my SV, note to all, do not use micron pipework as it hangs lower and so job needs to be done to make it work, ffs. The way I fitted the fairing means that the front cylinder pipe routes about 5cm lower than the bottom of the fairing. It looks like a proper botch job.

Ive also made a brilliant (as in good enough) job of spraying panels black.

Changed rear brake pads on ZX, oiled throttle cables.

ps. I hate fiberglassing

07-02-16, 10:09 PM	#676
TSM The Sick Man Mega Poster Join Date: Nov 2004 Location: Peckham.SE.LDN Posts: 4,768	Re: What have you tinkered with today? Today I have mostly been doing a crap job of fibreglassing the 675 fairings on my SV, note to all, do not use micron pipework as it hangs lower and so job needs to be done to make it work, ffs. The way I fitted the fairing means that the front cylinder pipe routes about 5cm lower than the bottom of the fairing. It looks like a proper botch job. Ive also made a brilliant (as in good enough) job of spraying panels black. Changed rear brake pads on ZX, oiled throttle cables. ps. I hate fiberglassing __________________ OTR: KTM 690 Duke R 2015 Full Akro SIDELINE: Kwak ZX636 A1P 2002, Red, R&G's, Yoshi, Double Bubble Screen GONE: Kwak ZX-7R P1, Full Akro, Undertray, Screen GONE: SV650S K2 Very Bruised & Without Fairing, Motovation Frame Sliders, R&G Ally Sprocket Toe Protector, HEL 2 Line Setup, GSXR K1 600 RWU Forks, Barnett Clutch & Springs, Penske 8981 Shock, Gilles Ti Rearsets, Steel Barends, Scottoiler, AFAM Chain & Sprockets, Twin FIAMM Horns, Skidmarx Bellypan, Full Micron Zeta Steel System, Cut down undertay. Forum Problems & Information / Site Suggestions