Re: Re: Pointy won't start after datatool S4 removal
Quote:
Originally Posted by daddyjob
Did you remember from where you removed the wiring from? You probably have to reconnect a circuit in order for the bike to start.
IIRC the alarm will use one of 2 circuits to prevent the bike from starting: 1) ignition 2) fuel pump
A Haynes manual has the full wiring circuit in it and a very useful thing to have. Need to make sure your getting power through the wires on both circuits to find out which one is not complete.
|
If I remember there is a strange loopthrough on the alarm connector circuit as well.
__________________
Learn to maintain your bike, take it apart, rebuild the engine & more (using better bolts  ), drop it & fix it again!
K3 Job c.v: Engine:remove/split/rebuild/refit. Replace:Gearbox,Fuel pump,Gaskets. Piston clean,rings. Overhaul:Throttle body,Injectors,Brakes,Forks. Remove/refit:Exhaust,Radiator,Oil cooler,Throttle,Air filter,Tank. Replace: Oil,Coolant,grease,brake hoses & bleed.
|