SV650.org - SV650 & Gladius 650 Forum - View Single Post

DuncanC · 22-04-18, 01:41 PM

When you say the white connector block is fine do you mean the 3 pin connector on the back of the bulb? Also Do you mean fine as in there is 12 Volts on the dip beam socket? How are you testing for fine? With a multi meter or just visually?
The only bit you haven't mentioned is the switch. They can get a build up of crud that can cause electrical faults.

22-04-18, 01:41 PM	#2
DuncanC Member Join Date: May 2016 Location: Wantage Posts: 68	Re: Low Beam Problem When you say the white connector block is fine do you mean the 3 pin connector on the back of the bulb? Also Do you mean fine as in there is 12 Volts on the dip beam socket? How are you testing for fine? With a multi meter or just visually? The only bit you haven't mentioned is the switch. They can get a build up of crud that can cause electrical faults.