View Single Post
Old 06-11-18, 04:49 PM   #17
Adam Ef
Member
Mega Poster
 
Adam Ef's Avatar
 
Join Date: Dec 2015
Location: Bristol
Posts: 1,200
Default Re: Trouble removing the exhaust

Cheers Bibio.
They can do MIG, TIG, brazing, work with Ti and all sorts so should be fine to get something fixed on... if I can get it there. If it fails I can still try drilling etc. They seem quite confident that they've done it a lot and offered to help. My decision is now is it more hassle to tray and reassemble to get it there or more hassle to try drilling it myself.



There's no access from the back on that bolt? It screws into a small box on the bracket that I assume the captive nut is held inside?


The collar pictured is all good apart from the degradation on that end couple of millimetres. Guessing its still ok to use? Do you use any sealant reassembling exhausts at the joins, or at the header or just allow the gasket to do it's job there?
Adam Ef is offline   Reply With Quote