SV650.org - SV650 & Gladius 650 Forum - View Single Post

Bibio · 10-10-18, 11:48 PM

move the expansion hose out the way with your fingers and you will see the cap.

i personally use a magnetic plug wrench.

what ever you do dont over tighten iridium plugs.

if you use a plug wrench to put the plugs in then use your fingers to tighten. if it goes tight within a few turns then you are xthreading so take out and try again. the plug should run pretty much all the way down by using your fingers on the wrench/extension.

10-10-18, 11:48 PM	#7
Bibio Member Mega Poster Join Date: Jul 2008 Location: here as devil's advocate Posts: 11,540	Re: Accessing rear side spark plug (K8) move the expansion hose out the way with your fingers and you will see the cap. i personally use a magnetic plug wrench. what ever you do dont over tighten iridium plugs. if you use a plug wrench to put the plugs in then use your fingers to tighten. if it goes tight within a few turns then you are xthreading so take out and try again. the plug should run pretty much all the way down by using your fingers on the wrench/extension.