SV650.org - SV650 & Gladius 650 Forum - View Single Post

17-10-13, 10:42 PM

Fair enough, I over-egged it in my head then thinking the electronics would make it harder.

I know where the vacuum take offs are, Is the screw accessed from above or below?

Also is it at all likely that the balance would be different between a standard exhaust and a viper can? Due to the noise of the viper it'd be good to balance them with the standard exhaust on then switch it to the viper once done.

17-10-13, 10:42 PM	#3
quik_d Guest Posts: n/a	Re: How to balance throttle bodies? Fair enough, I over-egged it in my head then thinking the electronics would make it harder. I know where the vacuum take offs are, Is the screw accessed from above or below? Also is it at all likely that the balance would be different between a standard exhaust and a viper can? Due to the noise of the viper it'd be good to balance them with the standard exhaust on then switch it to the viper once done.