Quote:
Originally Posted by Biker Biggles
Going back to your first few posts in this thread--------are you sure you know what you are doing? You wore out a chain in a very short mileage and you think the shop had left the chain too slack. You tightened it up yourself then it wore out. You mention it squeaking which is normally a symptom of being too tight. Too loose might result in banging as it hits the swingarm. Too tight will cause wear to the chain and maybe the gearbox but a bit too slack is unlikely to cause any problems unless it is slack enough to fall off. What you describe sounds like you have been running the chain too tight.
|
It was squeaking when the garage did the alignment and the slack not me. This is why I did not trust them the next time... I put the slack that was written in the manual, but I probably cocked up the alignment as I did it with naked eye.