Re: 2005 SV650s Valve Clearance Question
Quote:
Originally Posted by egcSV650s
Finally got round to getting the shims out and going by the chart the shims go up in .05 but ive got some shims which are saying 172 and 178?
Also i TDC the rear cylinder but the sprockets dont line up where there meant to be for TDC. The crankcase shows TDC but the markings on the sprockets dont. Ive attached a picture, black marking is where the markings are and red markings is where they should be. Can i just move them round to where there meant to be or will this cause problems
(Wont let me upload picture as its jpeg)
|
Try copy and paste of photo into MS Word document and either 'save as' older .doc (not more recent .docx) or save as PDF (a 'save as' option in MS Word) and post, it works for me as long as file not over size limit (don't try more than a couple of photos in one file). File size shriks a lot when saved as PDF and a little bit of definition lost but not really too bad.
__________________
2016 SV650 AL7
Courage is resistance to fear, mastery of fear, not absence of fear - Mark Twain
|