Quote:
Originally Posted by Bibio
hi mav. the crankset looks identical to the hollowtech II XT but its the earlier one without the locking hole on the main shaft at the single arm side. the main adjustment nut is about 22mm instead of the 20mm of the II.
i would guess that the II would slide straight into the bearing set though.
thanks |
The crank arm should butt up to the bottom bracket bearing without using the crank arm fixing bolt, it should just slide on to the splines on the spindle.
The crank arm fixing bolt is plastic and just puts tension onto the bearings, then do up the pinch bolts
Sorry if thats stating the obvious