[Bibio]

somebody had better bookmark this as i'm not digging all this info out again.

these sizes have been tried and tested on a topyokes conversion on an SV650 SK8 with Renthal Medium Road Bars. i have the whole kit here in front of me off the bike and it all worked perfect on the bike.

front brake hoses:
1 x 840mm eye centre to eye centre. 2x 20deg 10mm banjo.
1 x 800mm eye centre to eye centre. 1x straight 10mm banjo, 1x 20deg 10mm banjo. (right hand calliper)

throttle cables:
the ones i custom made have the longest inner at 890mm (were a tad too long) so you would have to measure the longest inner (thin cable) and see what the difference is.
remember that its not one size fits all due to different bars.

NOTE: if you want a perfect size then you need to install the top yoke, ignition switch, bars and throttle cable housing in the correct place then remove the cables from the throttle bodies, turn the bars to full (right) lock then measure the gap between the old cable and the throttle body lock nut adjuster allowing for a little wiggle room. once you have the difference in gap length then you jut get new cables mad up with that difference.

clutch cable:
Suzuki GSF 650 K5 Bandit 05 Clutch Cable
Outer is 108.5cm - Inner is 115.5cm