SV650.org - SV650 & Gladius 650 Forum - View Single Post

andy650 · 10-01-18, 06:05 PM

Check its not the gear lever, disconnect from change shaft (mark spline position) and check everything is smooth and free (lever pivot, 2 rose joints)

3-5mm play on clutch lever, use adjuster to set.

Chain needs to be right, too tight is worse.

When above is correct, does bike try to creep at all when in first and clutch fully pulled in?

If not, how far do you have to release the lever for it to start creeping?

10-01-18, 06:05 PM	#2
andy650 Member Join Date: Jun 2017 Posts: 132	Re: Gear/nautral issues Check its not the gear lever, disconnect from change shaft (mark spline position) and check everything is smooth and free (lever pivot, 2 rose joints) 3-5mm play on clutch lever, use adjuster to set. Chain needs to be right, too tight is worse. When above is correct, does bike try to creep at all when in first and clutch fully pulled in? If not, how far do you have to release the lever for it to start creeping? Last edited by andy650; 10-01-18 at 06:07 PM.