Re: Pointy no spark
its pretty simple. this is very very basic testing. you can do the same with a simple bulb tester rig.
stick the red DMM probe on/in the OUT wire (Orange/White) of the switch. turn your DMM to 20vdc and turn the bike on then put the stop/run switch to ON then place the black probe of the DMM to the frame or negative battery terminal if there is no voltage when the switch is ON then the switch is fubar.
to check you are getting power into the switch do the same as above but use the Orange/Black wire.
if you cant get at any terminals or solder blobs then stick probes through the insulation of the wire. once done put a blob of glue in the hole. or use a hot needle to melt/scrape a little insulation over the hole.
|