25-08-06, 02:19 PM
|
#8
|
|
The Sick Man
Mega Poster
Join Date: Nov 2004
Location: Peckham.SE.LDN
Posts: 4,768
|
Quote:
|
Originally Posted by jambo
I would check the valve clearances 1st of all, at the same time you can check that the markers on the cams line up perfectly (any alignment issues will be fairly obvious.
I could be completly wrong but wasn't the mod generally something about putting the exhaust cam in the inlet side or something? (This is seriously down to my screwey memory)  |
If you are using cams from K3+ bikes i think the timing marks did not line up at all so you had to use a diagram that is on SVrider or align up to TDC etc..blaaaaa. So it is possable that the cams are out of time by one notch.
__________________
OTR: KTM 690 Duke R 2015 Full Akro
SIDELINE: Kwak ZX636 A1P 2002, Red, R&G's, Yoshi, Double Bubble Screen
GONE: Kwak ZX-7R P1, Full Akro, Undertray, Screen
GONE: SV650S K2 Very Bruised & Without Fairing, Motovation Frame Sliders, R&G Ally Sprocket Toe Protector, HEL 2 Line Setup, GSXR K1 600 RWU Forks, Barnett Clutch & Springs, Penske 8981 Shock, Gilles Ti Rearsets, Steel Barends, Scottoiler, AFAM Chain & Sprockets, Twin FIAMM Horns, Skidmarx Bellypan, Full Micron Zeta Steel System, Cut down undertay.
Forum Problems & Information / Site Suggestions
|
|
|