Thread: Chain Monkey
View Single Post
Old 14-05-16, 11:12 PM   #9
Bibio
Member
Mega Poster
 
Bibio's Avatar
 
Join Date: Jul 2008
Location: here as devil's advocate
Posts: 11,539
Default Re: Chain Monkey

even cheeper... yes i'm Scottish. get a ruler and block of wood. place against swingarm mark where the manual says then cut the block of wood to fit under the swingarm and use that every time, or just use a ruler. me i just tighten till it just hits the slider. better a little loose than too tight. too tight will burger your output shaft bearings.

tiz not rocket science.
Bibio is offline   Reply With Quote