Re: 99 sv650n worm drive failure?
lets recap for people reading the thread who have fitted a new cable.
wind the lifter mech adjuster screw right out (but not fully out).
adjust the lever cable adjuster to half way.
take slack out the cable with the bottom cable adjuster.
turn the lever cable adjuster back down so there is slack in the cable.
adjust the lifter mech screw and lock off.
set bite point at lever adjuster.
if doing it my way then as above but leave the lever adjuster where it is then set the lifter mech screw in but dont back out, then set the bite point at the lever adjuster.
|