Hi,
Sorry about the long wait. I had to get hold of the standard bolts to replace the longer engine mount bolt etc.
The paint is looking a bit tatty in places. The only other thing I would mention is whilst checking everything was there I found a bolt and spacer for the brake light switch was missing. It could be replaced with a slightly longer bolt and a few washers. However, it wasn't on my bike and it didn't cause an issues. I also have a PDF copy of the fitting instructions that I can email over or print and put in the parcel, but as it is already assembled they are essentially:
Remove lower engine mount bolt.
Remove side stand.
Remover right hand footrest.
Put stand in place.
Refit all of the above with included longer bolts and spacer where necessary, except for the side stand which uses the standard bolts.
Adjust brake light switch.
Let me know if you are still interested, sorry again about the wait. I should be able to get it couriered out early next week now I have all the bits together.