Fitting Kyoto clutch plates

I ordered a kyoto clutch kit from wemoto, and it differs a bit from the standard set.
The standard kit has one plate fitted with rubber dampers, whilst in this kyoto kit, the equivalent part has no dampers (it looks just like a standard clutch plate).
The other 6 friction plates have a small semi circular notch cut in 3 of the teeth.

Pics included, is there any particular difference in fitting them, or in the order of fitting with this kit?

First plate put into the clutch basket:




Other 6 look like this:

[Viney]

If you can get the rubber bands off the old plates, then fit them. I had an EBC clutch and had enough issues with it, and i am sure it was due to the lack of these rubber bands on the 1st plate!

The kyoto plate doesnt have any notches to fit the rubber bands into.

[Viney]

If it was me, id make some! But i am not suggesting that you do. The plates may be of better quality than the EBC stuff, so therefore it may be ok. Keep the old clutch plate with the bands on it, and if you get any troubles, replace it with the other plate to see if it solves it!