safe to leave on paddock stands?

hello!! i've got hold of a pair of new Oxford paddock stands (front and rear).

the rear is on some bobbins - using hooks - nice and sturdy

and the front balances on two rubber pegs - which isn't very confidence inspiring at all!! and is even quite hard to get the bike up first time. - it takes a few goes at lining up and lifting.

So i was wondering if it's safe to leave my bike on both for a month or two in the garage? or is this a bad idea? maybe i should just leave it on the back stand?

thanks in advance
kev.

[DarrenSV650S]

No problem as long as you don't knock it. My sv is on paddock stands just now with no wheels on. If you are worried you could sling a ratchet strap over a roof joist and round the bike just in case

mine spent about 4 months on them with no issues, that included putting engine in and out and rebuilding set them right and they will be fine.

cheers

in theory it IS HOW your meant to store a bike if its to be left for a while, its not ideal leaving it on the side stand for a prelonged period of time.
I've heard its a good idea to let a bit of air out of the tyres as well.

[Stu]

Are you sure you haven't got the attachments for the frontstand on backwards?

[fastdruid]

I've never been impressed with the stability of those type of stands but as long as there is no chance of it being knocked it should be safe.

What I used to do though is pop the spindle back through and stick an axle stand under the middle of it. Stopped me worrying so much.

Now though I have one of the stands that lifts it under the headstock and don't have to worry



Druid

Got one of those headstock stand too but since I put the GSXR front its in the way of the wheel spindle

[fastdruid]

Originally Posted by hardhat_harry

Got one of those headstock stand too but since I put the GSXR front its in the way of the wheel spindle

Same as, need to turn the forks to get it out.

Druid

My pointy forks are not safe on my front paddock stand at all , one side with pinch bolt is ok the other will eventually pass through the prongs in a matter of minutes . I had an issue with mine one Wintery morning where the LH fork leg went through and bike went to topple over , I ran like Forrest Gump to the bike and managed to catch it and had to wedge a piece of wood against the side . I bought an Abba stand 10 minutes later . I have never trusted my front paddock stand at all on any bikes to be honest , they are Red Micron rip-offs and are cackola , yours and others may be better quality , these are fit for the bin to be honest and were a waste of £50 . Abba stand for me and I put a jack under the engine with a bit of wood to chock it up and raise the front end off the ground now .

[fastdruid]

I think they fit a little better on the GSXR forks than the SV forks. Only a little mind, they're still crap but one of the prongs sits under the adjuster screw and the other sits under the bottom of the fork, they seem mildly secure like that.

Druid