How to print off the template for custom fender eliminator?

I know this sounds stupid but how do you go about printing off the template you use for the custom made undertrays for Curvey SV's as im havin a bit of trouble with it lol?!

Would much appreciate any instructions or tips on how to?!

Oh yeh and if your quite computer minded and would know how to heres the link:
http://homepage.ntlworld.com/junej.h...odtemplate.htm

Just right click on the picture and select print!

Yeh i tryed that and it printed out with the whole thing on an A4 bit of paper not the correct scale and then the other time it printed out with just one part of it? I know its really dumb but i got an E in GCSE IT so not the best at working them.

[Wideboy]

if in XP just open it up in the "widows picture and fax viewer", click print and it will print it in 4 pages, the cut and join all the pieces where the dashed line is.

so your having ago then , give us a shout if you need any help I'm not far away

I got sh*tty vista it automatically scales down soddding thing.

Yeh deffinately up for it i'm wondering if instead of spraying black either polishing it but would it faid over time?

Is it a really good fit?

[Wideboy]

when i was at the stage before i sprayed it i put it on temp and took a photo (think i posted it) and i personally thought it looked crap.

Yorkie_Chris said about powder coating it which would be a better idea against corrosion, but i don't know how much this would cost and i think you mentioned you where on a budget in another thread.

if your going to spray it make sure you put plenty of coats on.

it will make a good fit if you ever so slightly bend the flanges upwards (i circled them in red in my thread) and it should sit plum with you plastics.

Yeh i guess the rest of the stock is black so might as well keep it black!

Yeh i'm just waiting till end of college course then going full time job so is limited as im a student lol!

Well i will get to work on it if i can get the template printed off lol!

Anyone good with vista at all?

[Wideboy]

lol i have my one on vista but i banished it to the corner of the room!!

there should be something in the printing options that says not to scale it down

It is the worst thing Bill Gates has ever created lol!

How many coats of lacquer did you put on it as i dont all the hard work wasted by it corroding after a while! Would it be worth spending the bit exra on stainless steel?