Pointy Valter Moto rearsets - silver

[Nobbylad]

I'm selling the Valter Moto rearsets I bought but off here but never got round to fitting.

There's a full set, plus a spare rhs hanger (as shown). There are some light surface scratches, but other than that, they're in good condition.

When I bought them, they didn't have the gear shift rod, the rose joint and end piece for connecting it or the brake light pressure switch (which is new in packing from HEL).

£80 + postage.

Do these have roller bearings? And do they fit the K3 model?

[Nobbylad]

Don't think they have roller bearings, think they will fit the K3, they're Type 1 as sold here....http://www.pdq1.co.uk/valter.htm

They're the ones you looked at last time...except with all the bits you need to use them.

[cbay]

Any of your bike left? lol

So will these go on a K8 easy fit then?

Any good?

[Nobbylad]

They go on easy enough in that the mounting holes, spacers and bolts provided are fine. I have never actually used them as a) it took me a while to get the rest of the bits I needed i.e. brake pressure switch and more importantly, the gear connecting rod/rose joint etc. and b) they would be OK for me on track days, but not sure I could live with them on the daily commute or with Nobbylass pillion.

I bought them not long after my 1st track day where I ground down a lot of the stock pegs and also snapped the rear brake pedal. I thought I'd just get some rearsets and then when they arrived, there were bits missing that took me ages to get around to getting. In the meantime, I just bought another rear brake pedal. The rearsets have been boxed up ever since.

[Nobbylad]

Bump before they go on ebay today.

hi buddy, could i have you phone number, think i might have them rearsets off ya. cheers

[Nobbylad]

PM'd

[Nobbylad]

sold

[Dave20046]

sigh ... too late