LED indicator flasher unit?

Hi can anyone help Iam trying to fit a flasher unit to stop indicators flashing quick but dont know what wires to cut into
thanks in advance

[Dave20046]

Time to consult the crystal ball?

Assuming it's an sv if you do a search it should be covered. From memory the second generation sv is brown and pale blue but probably wrong so have a look.

I have the same sort of problem. There is a post on here stating the same as Dave and yes it's the pale blue and brown wire but not sure which is positive and which negative.
On the same line, When fitting the undertray I noticed a red? relay in the left rear fairing (Same area as seat release) Does anyone know if this is the indicator relay?

Cheers

[cbay]

I bought this! It works! I didn't use it in the end but it works perfectly to sort out the problem, no cutting wires, fits perfect!!

http://cgi.ebay.co.uk/ws/eBayISAPI.d...m=390145732006

PLUS extra postage, was through my front door within like 2 days.

Purchased something similar from AceParts via e-bay. Just shy of £20 inc the postage. So much easier then the universal Relay. Just undo four bolts pull out the old relay from under the seat and replace with the new relay. 5 minutes, Job done.
Only one problem- Motrax indicators don't have a lot of thread on them so a bit of a pain replacing front indicators (not enough thread to go through indyspacers) biggest problem being that it was only 1 indicator in the pack but three packs and an annoyed dealer later all OK.