What could this be?

I've managed to adjust the clutch, so it's not slipping.

However, when on a long journey, like this morning, I stop for petrol, to refill, and when I get back on to ride off its really clunky getting into gear up or down.
but when I pull the revs on, she goes easily or or down the gears.

and then when in low revs again, she gets really clunky? is this normal?

Cheers

Mass

[Sid Squid]

When you say 'adjust' if what you did was move the cable adjusters, then what you may have done is adjust the cable - not the clutch.

Try this:

Originally Posted by I Previously

Slacken off cable adjusters at top and bottom, loosen lifter locknut, back out screw a bit, ensure that lifter arm is as far down as it will go, gently turn screw in until it contacts pushrod, back it out a bit, (~1/8th of a turn), then nip up the locknut, roughly adjust cable with lower adjuster - not too tight - then with top adjuster ensure that there remains a little slack all the way from lock to lock.