Mini indies on front.... how?

Just got Motrax arrow type indies and need to know is there an adaptor available for the fronts.

I can always design and make them myself but if anyone has any details I could use that would help.

Cheese!

i just modded the exsisting rubbers

Originally Posted by hovis

i just modded the exsisting rubbers

not to sure if you can see.........

motrax do adaptor plated 2 for each side, one in and one out, you can make these easily out of plastic.

[northwind]

I used a bit of plastic with a hole in, which I attached to the inside of the fairing using the OE metal ring and the 2 screws. Then I attached the indicators to that. Still does look slightly odd, but not too bad at all.

Originally Posted by northwind

I used a bit of plastic with a hole in, which I attached to the inside of the fairing using the OE metal ring and the 2 screws. Then I attached the indicators to that. Still does look slightly odd, but not too bad at all.

Yes I was thinking of that or what hovis had said. Both are not perfect cuz with the modded rubber it would stick out a bit too far but with the indies sitting in on there own there is that big gap allround. Oh well either way will look better than the big uglies.

i bodged mine too out of the stock rubber parts of the old one

Originally Posted by lylej

i bodged mine too out of the stock rubber parts of the old one

Spotty dog just cut the old ones down and works a treat