Right driver peg vibration.

Hi all have been having a problem with right foot peg drivers, vibrating , not constant , about 2500 revs , 30-35 mph, checked chain replaced rear wheel bearing as o3 model dont know when last done, replaced rubber damper also, anyway to day looked at peg , if grip with hand can move it about 5-7 ml, with a twist , shoud there be some play as fitting go's through fitting of rear brake pedal any ideals please,thinking need to retighten up bolts on back , when doing 60 mph or below no vibration.

[Bibio]

there should be no play apart from some on the actual foot peg. if the foot peg is rotating then yes the bolt at the back has come loose. pop a pic up so we can have a look.

[johnnyrod]

Like bibs says, the peg should be totally solid on the backing plate. There is enough clearance for the brake pedal to still work as you're not clamping it against the plate when you tighten the peg. You need to take off the backing plate to tighten it (unless you can get access) in which case I seem to remember it being easiest to bolt it back on back to front to hold it still while doing up the bolt.

Hi all , thanks for all your advice, when took of foot peg bracket , guess wot loose , now all done, blue treadlock and torqued up, up hope this is where all the vibration was coming from, many thanks again Jonny,bibio