k5 ignition switch removal

I have a 2005 sv650 race bike,power commander,hindle pipe and tre.Could someone tell me how to wire up an on-off flick switch so i can get rid of the ignition switch.I have tried searching the forum but cannot find any simple answer ie.colour of wires and where to connect them.The colour of the wires at switch are red, orange, orange/yellow stripe and brown/green rings.I have a 100ohm resistor which i believe you need.Charging system is standard.Any help much appreciated.

[Red Herring]

Hmmm....asking how to basically hot wire a bike at 04:29 hours in the morning is probably not going to get you much of a response......Perhaps we're just a suspicious lot?

Originally Posted by Red Herring

Hmmm....asking how to basically hot wire a bike at 04:29 hours in the morning is probably not going to get you much of a response

Your probably right but i'll try again.I work a late shift and i am only finished work this minute.I bought a home made lightweight clock bracket and the fairing stays foul the switch.I race in a minitwin series in ireland.I've posted a few questions before about frames and swingarms and i got a lot of help from zadar.Was hoping he could help me out again.I know it is basically asking how to hot wire a bike but i have seen it posted how to do it on the carb models.

same basic way on FI bike except resistor goes to different wire.