Shoei Pinlock - still fogs up - SV650.org

Stu · 12-01-09, 11:12 AM

My Shoei pinlock still fogs up

XR1000 bought in the summer came with the pinlock. I know the pins are ofset & I have gradually tightened them both up until the are now at they're tightest setting. There is no obvious gap but it still fogs up unless I am at motorway speed with the chin vent open or in town I have to crack open the visor.
I know it has been extra cold - but that is when you least want to open the visor, but even today wasn'y that cold, & on it''s tightest setting it still fogged up.

12-01-09, 11:18 AM

mine was doing this and i noticed when i put my tinted one in (you can see the seal better) that parts were either very thin or not even sealed, i mentioned it to the place i got it from and he said just to take it in, he would look at it and replace/sort it out.

also in order to find out where its not sealed take the visor off and breath on small areas at a time, may help may not!!

may be worth a try?

12-01-09, 11:43 AM

Not to sure about the shoei but bar of soap or fairy liquid solved the fogging issue with my agv.
Not sure if its much help but a quick fix none the less.

12-01-09, 11:44 AM

Mine fogs up in the mouth area, the condensation is too much because of the cold I think. Bit annoying too because when it fogs up it's more of an effort to check the speedo on the SV!

Mr Speirs · 12-01-09, 11:50 AM

Quote:

Originally Posted by sauluk

Mine fogs up in the mouth area, the condensation is too much because of the cold I think. Bit annoying too because when it fogs up it's more of an effort to check the speedo on the SV!

Honest Officer

yorkie_chris · 12-01-09, 12:38 PM

Perhaps a very thin layer of silicon grease around the seal?

13-01-09, 10:08 AM

Never had any problems with fogging on my pinlock/Shoei Raid II. Can only assume that the insert is faulty??

13-01-09, 12:50 PM

I'm on my third xr1000 now, no problems at all with the pinlock fogging. Just has to be a good fit.

13-01-09, 06:15 PM

Stu, is it fogging up inside (the side against the visor) or the outside of the Pinlock?

Stu · 13-01-09, 07:13 PM

Quote:

Originally Posted by Dangerous Dave

Stu, is it fogging up inside (the side against the visor) or the outside of the Pinlock?

i think both,
I have seen it inside the double glazing, but sometimes it's just on the outside of the pinlock (inside the helmet)

12-01-09, 11:12 AM	#1
Stu Trinity Mega Poster Join Date: Jun 2006 Location: Guildford Posts: 8,027	Shoei Pinlock - still fogs up My Shoei pinlock still fogs up XR1000 bought in the summer came with the pinlock. I know the pins are ofset & I have gradually tightened them both up until the are now at they're tightest setting. There is no obvious gap but it still fogs up unless I am at motorway speed with the chin vent open or in town I have to crack open the visor. I know it has been extra cold - but that is when you least want to open the visor, but even today wasn'y that cold, & on it''s tightest setting it still fogged up.

12-01-09, 11:18 AM	#2
arcdef Guest Posts: n/a	Re: Shoei Pinlock - still fogs up mine was doing this and i noticed when i put my tinted one in (you can see the seal better) that parts were either very thin or not even sealed, i mentioned it to the place i got it from and he said just to take it in, he would look at it and replace/sort it out. also in order to find out where its not sealed take the visor off and breath on small areas at a time, may help may not!! may be worth a try?

12-01-09, 11:43 AM	#3
BBadger Guest Posts: n/a	Re: Shoei Pinlock - still fogs up Not to sure about the shoei but bar of soap or fairy liquid solved the fogging issue with my agv. Not sure if its much help but a quick fix none the less.

12-01-09, 11:44 AM	#4
sauluk Guest Posts: n/a	Re: Shoei Pinlock - still fogs up Mine fogs up in the mouth area, the condensation is too much because of the cold I think. Bit annoying too because when it fogs up it's more of an effort to check the speedo on the SV!

12-01-09, 12:38 PM	#6
yorkie_chris Noisy Git Mega Poster Join Date: Apr 2007 Location: Halifax/Leeds Posts: 26,645	Re: Shoei Pinlock - still fogs up Perhaps a very thin layer of silicon grease around the seal? __________________ Currently Ex Biker Now rebuilding a 63' fishing trawler as a dive boat

13-01-09, 10:08 AM	#7
sparkymarky Guest Posts: n/a	Re: Shoei Pinlock - still fogs up Never had any problems with fogging on my pinlock/Shoei Raid II. Can only assume that the insert is faulty??

13-01-09, 12:50 PM	#8
Beenz Guest Posts: n/a	Re: Shoei Pinlock - still fogs up I'm on my third xr1000 now, no problems at all with the pinlock fogging. Just has to be a good fit.

13-01-09, 06:15 PM	#9
Dangerous Dave Guest Posts: n/a	Re: Shoei Pinlock - still fogs up Stu, is it fogging up inside (the side against the visor) or the outside of the Pinlock?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Pinlock Insert & Pins	COLZO	Helmets	4	18-12-08 01:22 AM
Shoei Pinlock Dark tinted insert	Stu	Stuff Wanted	10	07-05-08 10:15 AM
Shoei pinlock help	jonny bee	Helmets	5	10-02-08 12:10 PM
tinted pinlock?	hovis	Bikes - Talk & Issues	4	16-09-07 08:40 PM
Shoei Pinlock Visor problem!	The Polarbear	Bikes - Talk & Issues	5	19-04-05 08:03 PM