puig tail tidy help

just bought one from busters and the instruction's are crap all it say's about removing the snow shovel is dimantle license plate holder or something like that doesnt really help at all i can't see any bolt's on the outside and it look's as though they go through to under the seat lifted that up and couldnt see anything any help.

You will need to remove the rear seat cowling's, have a look on the Evotech website as they have the initial basic instructions on a Pdf document....

1. Remove the plastic covers at the sides of the petrol tank.
2. Remove the front and pillion seats, the grab rail, battery and toolkit.
3. Undo the pillion seat release cable from the subframe (1 screw) and detatch.
4. Remove the tail unit. (4 large screws, 4 plastic clips).
To remove the 4 plastic fasteners underneath the panel press the centre with a screwdriver and pull the whole fastener out. Disconnect rear light connector - the whole thing comes off in one piece-however you may find it easier to split the tail unit at the front joint.
5. Undo and remove the four bolts that hold the undertray in place (2 bolts each side of the subframe) and pull the undertray down, exposing 4 bolts securing rear fender.
6. Disconnect indicators and number plate light. Undo 4 bolts holding fender to subframe and remove the original plastic fender.
7. Swap indicators, number plate light and number plate onto new tail tidy bracket.

cheers dd cant believe ive got to go right up to the petrol tank to fit a tail tidy what a ball ache i'll give it a go at the weekend cheers.