How to fit M/cylinder seal set?

Hi,

Please could somebody tell me how to fit this master cylinder repair kit to my 2000w reg curvy?

its got a metal thingy with a screw like end, a spring, 2 rubber seals and a metal circlip.

cheers

[Dave20046]

Yep, remove the dustboot (rubber bit round the piston where the lever touches) pair of circlip pliers (they need to be narrow I had to grind mine down)> whip out the circlip, pull out the whole lot. Put the new rubbers on your new piston and put it all back in the way it came out.

And Ta Da!!!

[Dave20046]

Then say the magic word 3 times in rapid succession.

cheers guys,

I've actually got a mechanic coming over now to sort it as im being lazy so im going to pay him to do it

[Dave20046]

pah! lazy *******
Don't pay him too much only a ten minute job, allow him a 1 cup of tea limit.

lol hes a mate.

suzuki have given me a part that is too big.

is there a difference between the 750 and the sv650?

I recognise that bike! Good weekend?

[Dave20046]

Originally Posted by sv_rory

lol hes a mate.

suzuki have given me a part that is too big.

is there a difference between the 750 and the sv650?

As in the gsxr 750? It's likely.
*Sigh* This brings back memories; On your mastercylinder, on the side facing the rider as it's sat on your bar there should be a number i.e 5/8" it'll tell you the diameter of the piston you need for that cylinder.