where do i wire power from loom

for this speedo display, which wires do i conect the pos and neg wires to run the power, i dont want to run it from the battery so jumping on to the loom is easyiest but i need to know which wires to connect it to
eg: white and black wire going to blue big block connector and purple and green wire going to small blue block connector (just an example of the answer i need)
cheers people

[yorkie_chris]

Is there an orange going up to the stock clocks?

If you need a permanent live then there is a red wire going up there. This is always on regardless of ignition switch position, some clocks need this to maintain the memory of trip counter/clock setting.

-ve is the black wire with white tracer.

aahhh thankyou aahh thankyou very much

[yorkie_chris]

I will find for certain tomorrow. There is no haynes manual in this house?!?! How do people live like that, if I had house, manuals and tools would be in before sofas!

Checked the Suzuki wiring diagram for a K2

Black with white tracer (there should be two, both) = -ve
Red with white tracer on loom side, red only on clock side = permanent +ve
Orange with Green tracer = switched +ve

Check it with a multi meter to confirm before attaching anything.

HTH

mmmmm not working, will call you both idiots tomorrow before you tell me ive done something wrong and then i'll say thanks while muttering under my breath