Specs of bolts required.

I am replacing the standard undertray/battery box on my K3 as the original one was cut to fit an aftermarket undertray on to it.

There are two bolts that fix by the battery section and also further up a couple of further bolts towards the end. The ones by the battery seem to go in so I assume they would be the same as these?

I need to know what the specs are for the ones that fix towards the end.


Also I am fitting it together with an R&G Tail Tidy and upon reading the instructions, it says to fix the brackets that the tail tidy is fixed to, to use the OEM bolts I am assuming from the snow plough that would of been removed.

http://www.rg-racing.com/Images/Prod.../pdf286_83.pdf

On the instructions, you can see the brackets on the picture on the right hand side.

So this is my second question, what size and spec are these bolts as I don't have any clue on this one.

Any help much appreciated

[Geodude]

If this link has worked im guessing (as i have a curvy) that its part number 2 or 4 which gives the part number 09116-06098-XC0 and a size of m6x14. Have a check for yourself though or pm darrensv650s as he has a k3. HTH

Edit: link not giving direct page. click on 2003-k3 then scroll down and click on 2003 sv650,s then scroll down again and click on rear fender (model k3) and that will give you the diagram and part numbers/size etc.

That is a great link, many thanks for your help.

I may finally be able to put my bike back together

[Geodude]

No problems bud, glad to be of some help

Originally Posted by Geodude

09116-06098-XC0

Bolox! I just spent 10 minutes finding that part number on Ronayers.com, then I read the thread and realised it was already sorted.

http://www.ronayers.com/Fiche/TypeID...NDER_(MODEL_K3)

[Geodude]

Twice the help is better than no help