Sv 650 k5 fairing fittings questions.

[Denethor]

Sorry for the language but I'm using
Google translator.
First of all pleasure are Francis and this
is the first time I write in this forum.
I have a K5 sv650 that I bought a used
original suzuki lower fairing.
Unfortunately the former owner I have
been given all the parts so I'll have to
get me.
You wonder if you can kindly give me
the size of the holes and the distance
between the centers of two holes in the
lower bracket that goes around the
easel.
I would also measure the bushings that
go in the hole in the top of the hull, one
where it joins the side of the fairing. The
manual says it should be 15x13.5 but
what they refer to those dimensions?
Can you give me all the dimensions?
thanks

Inviato dal mio ViewSonic-V350 usando Tapatalk

[Denethor]

anyone?

[Nobbylad]

Can you post a picture of the holes you are talking about?

[Denethor]

In this picture there are both parts that interest me.

The bushing with flange is indicated with the letter O

And the bracket with the letter W

http://sites.google.com/site/garratt/DSC03077.JPG

I want to know the size of the bushing with flange O (diameter, length)



and the dimensions of the bracket W (distance between holes center to center) the same as indicated by the yellow arrow you



thanks

[Nobbylad]

Grommets for the small holes are => http://www.mossexpress.co.uk/mss/mss...y&search=10770

Grommets for the fairing spacer/crash bung holes are => http://www.mossexpress.co.uk/mss/mss...y&search=15104

With regards to the top hat bushes => they are 9mm high, internal diameter is 6mm, external diameter is 8mm, outside diameter (on the washer/top hat face) is 14mm and 1mm thick.



Hope this helps
With regards to the hole centres for the plate, they are roughly 40mm apart.

[Denethor]

Thank you for the information but you gave me the measurements of small bush that manual says to be 14x8,5, to me is the measure of the bushing that goes in the only forum in which the two fairing (the lower fairing and upper fairing) overlap should be slightly larger than a bush and longer.


Can you give me the dimensions of the bracket to the hull gets near the sidestand? And as indicated by the yellow arrow in your picture!


Thank you for your kindness and help over the weekend looking for the Allen key and take the size of the bolt that interesting to you

Inviato dal mio ViewSonic-V350 usando Tapatalk