TRE mod on a SK4 - SV650.org

15-05-05, 06:42 PM

Just done the TRE mod as described in the "HOW TOO" section, the bike starts and revs OK , according to the mod description the revs should rise as soon as i pull in the clutch but they don't. Any ideas please.

15-05-05, 09:15 PM

make sure you have conected the resistor to the wires that go back to the ecu and not the gearbox.

Regards Dave.

ophic · 16-05-05, 06:07 AM

Think this is mainly noticeable when cold, so if your engine is warm it may not do it.

16-05-05, 06:22 AM

Using the Ophic Mk 1 special TRE MOD Kit I found the job to be a success on my K3.The increase in revs mentioned is only slight, perhaps a couple of hundred rpm maybe your expecting it to flick round to the red line?

15-05-05, 06:42 PM	#1
kashby Guest Posts: n/a	TRE mod on a SK4 Just done the TRE mod as described in the "HOW TOO" section, the bike starts and revs OK , according to the mod description the revs should rise as soon as i pull in the clutch but they don't. Any ideas please.

15-05-05, 09:15 PM	#2
dragon1 Guest Posts: n/a	tre mod make sure you have conected the resistor to the wires that go back to the ecu and not the gearbox. Regards Dave.

16-05-05, 06:07 AM	#3
ophic Member Mega Poster Join Date: Jan 2004 Location: Whyteleafe Posts: 3,395	Think this is mainly noticeable when cold, so if your engine is warm it may not do it. __________________ Silver SV650SK3, Fuel exhaust

16-05-05, 06:22 AM	#4
Peter Henry Guest Posts: n/a	Using the Ophic Mk 1 special TRE MOD Kit I found the job to be a success on my K3.The increase in revs mentioned is only slight, perhaps a couple of hundred rpm maybe your expecting it to flick round to the red line?