botched frankenstein????

All ive done so far is to make up some new infills for either side of the rear light from thin plastic and sprayed them black to see what it looks like.

Its better than in this picture, (that was silver gaffa tape to try and keep the water out, the standard snow plough does a good job at keeping water spray to a minimum ) but im not happy with them, the complex shape needs work to get it looking right. Ive been thinking about getting a tub of filler out and seeing what I can make.

Originally Posted by leebex

gave the sv a much needed clean so thought Id post up a pic, its done 30k now.

Ive got a few jobs to finish, the fairing lowers and the under seat infills are off being smoothed and cleaned up and will be done in the proper yellow. I also must get round to making the small infills for each side of the pointy light.



The wood block is just to hold the bike upright a bit for cleaning.

Lee

[NTECUK]

Maybe the fine mesh used in vents might look the part .