Bought My SV a little present :)

cmon out of all the things i could have said that was probably the best!
but back on topic if you need a hand fitting it im sure you will find a lot of us willing to supervise!

Do yourself a favour and get rid of the mickey mouse sticker, though.

If you leave it on for too long after you start using the bike it'll be next to impossible to get rid of the glue stains...

i'll fit it myself just need to give myself some time to do it. probably this Sunday morning. Can't imagine it would be that hard only one cut in the pipe involved

yep its nice and simple!

Originally Posted by ad53ggz

yep its nice and simple!

Famous last words.

[Bibio]

9 inch grinder straight threw no problems... just remember to protect everything if you are leaving the pipework on the bike. also use some masking tape wrapped round pipe then mark for cut then cut. take footpeg off at the pin lets you get into the pipe easier..

[dyzio]

And don't cut the swing arm!

Originally Posted by Stoneyginger

i'm assuming i would cut about an inch above the weld next to the little hanger bit at the bottom?

You're assuming? It doesn't come with instructions? Good luck.

Don't use a junior hacksaw, it takes days.....

i bought it online second hand but it is basically brand new and seems to line up perfectly oooooooooh dont worry i have a grinder to hand