SV Talk, Tuning & Tweaking Discussion and chat on all topics and technical stuff related to the SV650 and SV1000 Need Help: Try Searching before posting |
![]() |
|
Thread Tools |
![]() |
#11 |
Guest
Posts: n/a
|
![]()
I believe Scorpion says to cut the exhaust 1 3/4" inches above the weld. While most other manufactures of slip on exhaust say cut the pipe 2" inches above the weld. So looks like your only talking about a 1/4" inch differance. I don't believe thats anything to worry about my friend.
Cheers, Richard |
![]() |
![]() |
#12 |
Guest
Posts: n/a
|
![]()
The odd 1/4--1/2 --3/4 inch doesn't matter if the system you are fitting has an independent bracket for mounting the can[you just slide it back or forward to suit] It is only if the system has a fixed bracket for fixing the can that the cut in the exhaust is crucial
|
![]() |
![]() |
#13 |
Guest
Posts: n/a
|
![]()
I found a 9" angle grinder sorted it in seconds. Ask your neighbours n friends or hire one. Cover all area's for sparks first, The pipe is thicker than you think as it has a perforated stainless liner inside.A hacksaw will kill you.
|
![]() |
![]() |
#14 |
Guest
Posts: n/a
|
![]()
Thread hijack, sorry. thowdmon i notice that you have a FUEL end can, any good?
spudnuts. |
![]() |
![]() |
#15 |
Guest
Posts: n/a
|
![]()
Well made, great noise, legally stamped with rem baffles.Looks well, keep your eye on E-bay, mine was £80 new.
|
![]() |
![]() |
#16 |
Guest
Posts: n/a
|
![]()
Yeah thanks, have seen them on E-bay just wondered what they were like.
spudnuts. |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
oil issues | Brettus | SV Talk, Tuning & Tweaking | 9 | 24-11-08 08:39 PM |
3 Issues | Phaelok | Bikes - Talk & Issues | 11 | 28-10-08 11:06 PM |
Crash.NET - Rossi: Great race in dry, no race in wet? | NewsBot | News | 0 | 13-09-08 10:40 PM |
DNS Issues | Jelster | Idle Banter | 6 | 05-02-07 05:59 PM |
Race Sponsorship - Race For A Season For 20 Quid | Mike1234 | SV Talk, Tuning & Tweaking | 0 | 01-01-06 06:10 PM |