13-05-21, 08:49 AM | #2271 |
Member
Mega Poster
Join Date: May 2015
Posts: 1,273
|
Re: What have you tinkered with today?
Does the VFR use different-thickness buckets to adjust the clearances, instead of shims?
My daughter's Aygo uses this method, the valve check interval is 60,000 miles, although the motor doesn't rev as high so you'd expect less wear. |
13-05-21, 12:24 PM | #2272 |
Member
Mega Poster
Join Date: Dec 2015
Location: Bristol
Posts: 1,200
|
Re: What have you tinkered with today?
Yes it does on the VTEC valves. The non VTEC ones are regular shims. The VTEC buckets are £25 each. Glad I managed to swap a couple around. I still spent about £350 on parts for this job in the end though.
__________________
>>> ? <<< Past: Street Triple 765rs, DRZ400s,GSXR1000 K9, VFR800 A8, ZX6R 636 2006, CRF250L, GSXR750 K7, VFR800 A7, GSXR750 L3, Street Triple 675R, MT09 Tracer, SV650s K8, CB250rsd, YBR125... |
13-05-21, 12:36 PM | #2273 |
Member
Mega Poster
Join Date: May 2015
Posts: 1,273
|
Re: What have you tinkered with today?
Ooof, no wonder a lot of people put it off, or just never do it ...
|
14-05-21, 03:02 PM | #2274 |
Member
Mega Poster
Join Date: Jul 2008
Location: here as devil's advocate
Posts: 11,552
|
Re: What have you tinkered with today?
new discs and pads on the bike (again). got all my kit on to go for a ride only to get round the block due to bike running like a pile of poo..
why this bike goes through discs is anybody's guess but this is the 4 sets since i have owned the bike. |
14-05-21, 11:36 PM | #2275 |
Member
Join Date: Sep 2020
Location: North Yorkshire
Posts: 373
|
Re: What have you tinkered with today?
|
14-05-21, 11:38 PM | #2276 | |
Member
Join Date: Sep 2020
Location: North Yorkshire
Posts: 373
|
Re: What have you tinkered with today?
Quote:
There must be some explanation for your bike going through so many discs. |
|
15-05-21, 01:14 PM | #2277 |
Member
Mega Poster
Join Date: Jul 2008
Location: Sheffield
Posts: 10,274
|
Re: What have you tinkered with today?
Are the discs wearing below threshold bib or warping?
__________________
|
15-05-21, 02:50 PM | #2278 |
Member
Mega Poster
Join Date: Jul 2008
Location: here as devil's advocate
Posts: 11,552
|
Re: What have you tinkered with today?
cleaned the rec/reg terminals which then showed that the battery was feked. voltage dropped from 12v to 10v instantly and kept dropping when the ignition was turned on. new battery and things are charging like they should. so a combo of dirty rec/reg terminals and feked battery, i hope.
|
15-05-21, 02:52 PM | #2279 |
Member
Mega Poster
Join Date: Jul 2008
Location: here as devil's advocate
Posts: 11,552
|
Re: What have you tinkered with today?
|
15-05-21, 05:11 PM | #2280 |
Member
Join Date: Jan 2019
Location: N W Leicestershire
Posts: 262
|
Re: What have you tinkered with today?
Discs wearing? Using them too much - after all they only slow you down!
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Been got already today.. | 454697819 | Idle Banter | 16 | 01-04-10 02:08 PM |
Today | DaveP | The Border Patrol | 4 | 02-03-10 10:52 AM |
Going out today? | tj2 | The Border Patrol | 1 | 01-06-09 09:22 PM |
Today | Tara | Guildford Massive | 14 | 02-06-08 11:56 AM |
Today...... | Caddy2000 | Idle Banter | 15 | 19-04-06 05:39 PM |