Adjustable Rearsets

Originally Posted by BillyC

I think I'll probably get the GBMoto ones as things are quite desperate now.

Where can I get one of those pressure switches?

Demon Tweeks

http://www.demon-tweeks.co.uk/produc...e=GDRBL992-31C

You want a 10x1.25 single bolt in stainless steel - ?15.11

HTH

Originally Posted by Lozzo

Demon Tweeks

http://www.demon-tweeks.co.uk/produc...e=GDRBL992-31C

You want a 10x1.25 single bolt in stainless steel - ?15.11

HTH

9.95 and postage free.

And thanks to Lozzo you now know the thread type.


http://cgi.ebay.co.uk/Hel-Performanc...QQcmdZViewItem

Originally Posted by yorkie_chris

Who's used them? Do you notice losing the heel plate?

You don't lose the heel plate on the GBMoto ones, if you can fit the master cylinder then you can fit a heel plate. Not sure if GBMoto supply one but you can fit one.

I have the Rosmoto's from JHS and I don't have a heel plate on the left hand side, never had any problems without it.

Originally Posted by Dangerous Dave

You don't lose the heel plate on the GBMoto ones, if you can fit the master cylinder then you can fit a heel plate. Not sure if GBMoto supply one but you can fit one.

I have the Rosmoto's from JHS and I don't have a heel plate on the left hand side, never had any problems without it.

You get both heel plates with the GBMoto rearsets and both can be fitted to the pointy with the original m/cyl.

I'm not sure about the curvy though.